I am selling a fully fully functional JOBO CPA-2 Processor with a 4072 new style lift, 95523 black main drive cog, and double-bearing rotation motor upgrade (not the later Expert drum motor upgrade). Includes eight JOBO 1000 mL bottles, four JOBO 260 mL beakers, an Eastman Kodak thermometer, and parts left over from the lift conversion (95123 drive magnet and screws, 07069 roller block, pair of 07007 white rollers, and a pair of 92167 black rollers with extensions).
I tested this CPA-2 this past weekend using a 1540 MultiTank (not included). There were no leaks, the pump circulated water, the tank rotated back and forth, and the lift worked as expected. I heated the water bath to 35ºC (95ºF) which was 25ºF above ambient air temperature. The temperature dial was set to 34.5ºC — one half a degree Celsius below the actual temperature, which I understand is very common for CPA-2 processors. I was unable to test temperature range precision, as my testing was done on a sunny day in a garage (fine for B&W processing). Water bath temperature held steady at 95°F and then crept up to 96°F as the ambient air temperature went from 70°F to 71°F over a period of 45 minutes.