...
▲
favorite
favorite
hide
unhide
flag
flagged

Posted

Contact Information:

print

ORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 - $195 (san jose south)

‹ image 1 of 15 ›
ORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 1
ORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 1 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 2 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 3 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 4 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 5 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 6 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 7 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 8 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 9 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 10 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 11 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 12 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 13 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 14 thumbnailORIGINAL Pre-Unit TRIUMPH 650 CYLINDER BARREL Standard BORE 6T T120 15 thumbnail
condition: excellent
make / manufacturer: TRIUMPH
model name / number: 70-3332

QR Code Link to This Post

Original 1956-62 Triumph PRE-UNIT 650 8-BOLT CYLINDER BARREL in EXCELLENT condition, For Sale in San Jose CA $195 or BEST OFFER. ORIGINAL Meriden production, casting number/part number E3332 on the base flange. ALL fins STRAIGHT & INTACT, NO cracks in spigots, NO rust or defects in cylinder bores. Both bores measure 2.796" at the bottom below the ring travel (only .001" over the nominal STD bore 2.795" or 71mm) and 2.800" at the top for .004" total taper. Depending on actual piston diameter, with a fresh hone there is a good chance you could run STANDARD 71mm pistons, or re-bore to +.010 or +.020. Photos show cylinder as stored with grease on all the bare iron - bores have since been cleaned - NO scoring, NO pitting, clean smooth surfaces throughout.

A VERY NICE 8-BOLT CYLINDER BARREL for your pre-unit 650 Triumph, as used on all 650 models from 1956 on, will FIT and WORK on all earlier 650 models back to 1950.

Offered here at $195 or BEST OFFER, plus shipping from San Jose California - HAPPY to ship ANYWHERE on the PLANET at cost.

post id: 7894838979

posted:

♥ best of [?]

loading
reading
writing
saving
searching

refresh the page.